pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration pipe restoration
pipe restoration pipe restoration
pipe restoration pipe restoration
pipe restoration Home pipe restoration Company History pipe restoration

Why PRT?

pipe restoration Our Solution pipe restoration FAQs pipe restoration Request A Bid pipe restoration Contact Us pipe restoration pipe restoration
pipe restoration pipe restoration
  pipe restoration
pipe restoration pipe restoration pipe restoration
pipe restoration pipe restoration

Epoxy vs. Repipe | PRT vs. Competition

PRT vs. Competition

PRT
The Competition
 Shut off water – drain system
Shut off water – drain system
Clean
  • IF we decide we must dry pipe system – we use ‘Drying Agent’ which accelerates the drying process (Note: warm air doesn’t work well in wet or humid climates)
  • ‘Sand Blast’ if appropriate
  • Use PRT developed cleaning method
 
  • Dry interior of pipes using warm air (NOTE: Using this method, can take 3 to 4 days to dry out system in wet climate)
  • ‘Sand Blast’ interior of pipe to clean build up (Note: MUST dry pipes before sandblasting will work)
Epoxy
  • Use PRT developed injection method, with pre- filled, pre-measured cartridges at ‘point of injection’
  • Faster
  • Easier
  • Safer
  • Cleaner

Use GrizzlyKote™ epoxy – specially developed and formulated for use in pipe coating to prevent sagging and pooling.
  • Use ‘static mixer’ at remote location on site to fill random sized ‘shot tubes’ with epoxy – then carry to ‘point of injection’

Use other epoxy material.

PRT - GrizzlyKote™ Epoxy vs Competitors Epoxy
Cure Time 5 hours – Certified 24 hours – Certified (Note: 1 competitor has 5 hour)
Temperature Rating Commercial Hot @ 180° F Domestic Hot @ 140° F (Note: 1 competitor rated @ commercial hot)
Practical Application Thickness 10 to 30 mils 10 to 30 mils
Minimum Flush Time 15 minutes 1 hour (Note: 1 competitor also has 15 minute)

Our Technology, Our Process, and Our Epoxy are the most technically advanced pipe lining system available.
pipe restoration
Home | History of PRT | Why PRT? | Applications | FAQs | Request A Bid | Licensee Information | Contact Us

© Copyright 2011 Pipe Restoration Technologies. All Rights Reserved.
Main: (714) 970-1635 FAX: (714) 632-1818 | info@prtcoatings.com

Website Design, Development, Hosting Provided By Inland Light.
pipe restoration